Assessment of the nature of interactions of cations with cycloheptatriene derivatives using change in the aromaticity: Comparison with electron density and NBO results

ABSTRACT

Interactions of cycloheptatriene derivatives, C₇H₆X, (X?=?NH, PH, AsH, O, S, Se) with the cations H⁺, CH₃⁺, Cu⁺, Al⁺, Li⁺, Na⁺, and K⁺ are studied using B3LYP functional and 6-311++G(d,p) basis set. The calculated gas-phase cation affinities (CA) and cation basicities (CB) for all molecules decrease as H⁺ > CH₃⁺ > Cu⁺ > Al⁺ > Li⁺ > Na⁺ > K⁺. We used the induced aromaticity in the 7-membered ring of C₇H₆X upon interaction with the cations, M⁺, as a measure of C₇H₆X/M⁺ interaction. Nucleus-independent chemical shift (NICS) and harmonic oscillator model of aromaticity (HOMA) were used as two indices of aromaticity. The highest and lowest induced aromaticities were observed for interactions of H⁺ and K⁺, respectively. Also, the aromaticity induced by interaction with a cation in C₇H₆AsH and C₇H₆PH was larger than that in C₇H₆NH and C₇H₆O. Hence, the aromaticity was considered as a measure of covalency for the C₇H₆X/M⁺ interactions showing a rational dependence on both the molecule and cation. The nature of the interactions was also assessed using electron density, charge distribution analysis and NBO calculations. The results of the aromaticity indices, NICS and HOMA, were compared with the electron density and NBO results.     

基于CARS技术的超燃冲压发动机点火过程温度测量

相干anti-Stokes Raman散射（coherent anti-Stokes Raman scattering，CARS）技术作为一种非接触测量手段，已广泛应用于多种发动机模型燃烧室温度测量及地面试验.然而，目前的工作主要集中在稳态燃烧场温度的测量，缺乏用高分辨率的单脉冲来测量瞬变的燃烧火焰温度及组分浓度的研究.基于CARS理论，结合多参数拟合算法，开发了基于MATLAB的CARS光谱计算和拟合程序CARSCF；利用McKenna平面火焰炉在不同工况下进行了温度测量，并与DLR测量结果进行对比，结果显示开发的CARSCF具有较高的测量重复性和准确性；最后将CARS技术应用于测量超燃冲压发动机点火过程中的温度测量，获取了点火过程中的温度.结果显示，在来流Mach数为3的条件下，H₂/air点火过程中温度呈现急剧上升然后缓慢下降，而CARS信号则呈现急剧上升然后急剧下降随后又缓慢上升的趋势，并且在点火过程中最高温度为1 511 K.      

Scattering of Tollmien-Schlichting waves by localized roughness in transonic boundary layers

The laminar-turbulent transition in boundary-layer flows is often affected by wall imperfections, because the latter may interact with either the freestream perturbations or the oncoming boundary-layer instability modes, leading to a modification of the accumulation of the normal modes. The present paper particularly focuses on the latter mechanism in a transonic boundary layer, namely, the effect of a two-dimensional(2 D) roughness element on the oncoming Tollmien-Schlichting(T-S) modes when they propagate through the region of the rapid mean-flow distortion induced by the roughness. The wave scattering is analyzed by adapting the local scattering theory developed for subsonic boundary layers(WU, X. S. and DONG, M. A local scattering theory for the effects of isolated roughness on boundary-layer instability and transition: transmission coefficient as an eigenvalue. Journal of Fluid Mechanics, 794, 68–108(2006)) to the transonic regime, and a transmission coefficient is introduced to characterize the effect of the roughness. In the sub-transonic regime, in which the Mach number is close to, but less than, 1, the scattering system reduces to an eigenvalue problem with the transmission coefficient being the eigenvalue; while in the super-transonic regime, in which the Mach number is slightly greater than 1, the scattering system becomes a high-dimensional group of linear equations with the transmission coefficient being solved afterward. In the largeReynolds-number asymptotic theory, the K′arm′an-Guderley parameter is introduced to quantify the effect of the Mach number. A systematical parametric study is carried out,and the dependence of the transmission coefficient on the roughness shape, the frequency of the oncoming mode, and the K′arm′an-Guderley parameter is provided.     

Magnetite nanoparticles−based hydroxyl radical scavenging activity assay of antioxidants using N,N-dimethyl-p-phenylenediamine probe

Excessive amounts of reactive oxygen species (ROS), unless counterbalanced by antioxidants, can cause cellular damage under oxidative stress conditions; therefore, antioxidative defenses against ROS must be measured. With the development of nanotechnology, nanoparticles have found numerous applications in science, health, and industries. Magnetite nanoparticles (Fe ₃ O ₄ :MNPs) have attracted attention because of their peroxidase-like activity. In this study, hydroxyl radicals (•OH) generated by MNPs-catalyzed degradation of H ₂ O ₂ converted the N,N-dimethyl-p-phenylenediamine (DMPD) probe into its colored DMPD•+ radical cation, which gave an absorbance maximum at λ = 553 nm. In the presence of antioxidants, •OH was partly scavenged by antioxidants and produced less DMPD• ⁺ , causing a decrease in the 553 nm-absorbance. Antioxidant concentrations were calculated with the aid of absorbance differences between the reference and sample solutions. The linear working ranges and trolox equivalent antioxidant capacity coefficients of different classes of antioxidants were determined by applying the developed method. In addition, binary and ternary mixtures of antioxidants were tested to observe the additivity of absorbances of mixture constituents. The method was applied to real samples such as orange juice and green tea. Student t-test, F tests, and the Spearman’s rank correlation coefficient were used for statistical comparisons.     

Momentum and heat transfer of a special case of the unsteady stagnation-point flow

This paper investigates the unsteady stagnation-point flow and heat transfer over a moving plate with mass transfer,which is also an exact solution to the unsteady Navier-Stokes(NS)equations.The boundary layer energy equation is solved with the closed form solutions for prescribed wall temperature and prescribed wall heat flux conditions.The wall temperature and heat flux have power dependence on both time and spatial distance.The solution domain,the velocity distribution,the flow field,and the temperature distribution in the fluids are studied for different controlling parameters.These parameters include the Prandtl number,the mass transfer parameter at the wall,the wall moving parameter,the time power index,and the spatial power index.It is found that two solution branches exist for certain combinations of the controlling parameters for the flow and heat transfer problems.The heat transfer solutions are given by the confluent hypergeometric function of the first kind,which can be simplified into the incomplete gamma functions for special conditions.The wall heat flux and temperature profiles show very complicated variation behaviors.The wall heat flux can have multiple poles under certain given controlling parameters,and the temperature can have significant oscillations with overshoot and negative values in the boundary layers.The relationship between the number of poles in the wall heat flux and the number of zero-crossing points is identified.The difference in the results of the prescribed wall temperature case and the prescribed wall heat flux case is analyzed.Results given in this paper provide a rare closed form analytical solution to the entire unsteady NS equations,which can be used as a benchmark problem for numerical code validation.     

Comparative study on Artemisia halodendron Turcz. and its two related plants by GC-MS analysis and protective effect against carbon tetrachloride-induced hepatotoxicity in mice

A rapid method had been used for comparative study on Artemisia halodendron Turcz. and its two related plants by gas phase-mass spectrometry (GC-MS). The comparison of the volatile oils obtained in three plants by GC-MS were similar in 20 compositions. However, n-Hexadecanoic acid (10.40%), Biphenyl (7.867%) and 9,12-Octadecadienoic acid (7.25%) were the predominant in the volatile oils of A. halodendron Turcz., whereas these constituents did not exist in the other two plants. And the study investigated the effect of three plants against CCl₄-induced hepatotoxicity in mice. 70% ethanol extracts of A. halodendron Turcz. showed weaker protective effect than the other two plants. It suggested that they provide a basis for the identification of the A. halodendron Turcz. from the other two plants and the ethanol extract from three plants exerted a protecting effect against hepatotoxicity.     

Recent trends in capillary and micro-chip electrophoretic instrumentation for field-analysis

Technical advances in the development of field-deployable capillary and microchip electrophoretic instruments and reports of their deployment between 2013 and 2017 were reviewed. Strategies and considerations in the design of the injection, separation and detection hardware, chemistry and associated infrastructure were discussed from an in-field perspective, with portability, robustness and automation/“ease of use” featuring as key requirements. Integration of functionality is important for adequate in-field performance. Progress was made towards the use of multiple channel devices for increased throughput and/or resolving power, mixing devices for on-line/in-line sample derivatization, battery operation and temperature control. The strengths and weaknesses of the various approaches described in the literature are discussed from the perspective of in-field operation. An overview of the applications of the field electrophoretic instruments is provided, including environmental science and planetary investigation.     

A Comparison of Two Isoreticular Metal–Organic Frameworks with Cationic and Neutral Skeletons: Stability,Mechanism, and Catalytic Activity

Although many ionic metal–organic frameworks (MOFs) have been reported, little is known about how the charge of the skeleton affects the properties of the MOF materials. Herein we report how the chemical stability of MOFs can be substantially improved through embedding electrostatic interactions in structure. A MOF with a cationic skeleton is impervious to extremely acidic, oxidative, reductive, and high ionic strength conditions, such as 12 m HCl (301 days), aqua regia (86 days), H₂O₂ (30 days), and seawater (30 days), which is unprecedented for MOFs. DFT calculations suggested that steric hinderance and the repulsive interaction of the cationic framework toward positively charged species in microenvironments protects the vulnerable bonds in the structure. Diverse functionalities can be bestowed by substituting the counterions of the charged framework with identically charged functional species, which broadens the horizon in the design of MOFs adaptable to a demanding environment with specific functionalities.     

Molecularly Engineered 6FDA-Based Polyimide Membranes for Sour Natural Gas Separation

Glassy polyimide membranes are attractive for industrial applications in sour natural gas purification. Unfortunately, the lack of fundamental understanding of relationships between polyimide chemical structures and their gas transport properties in the presence of H₂S constrains the design and engineering of advanced membranes for such challenging applications. Herein, 6FDA-based polyimide membranes with engineered structures were synthesized to tune their CO₂/CH₄ and H₂S/CH₄ separation performances and plasticization properties. Under ternary mixed sour gas feeds, controlling polymer chain packing and plasticization tendency of such polyimide membranes via tuning the chemical structures were found to offer better combined H₂S and CO₂ removal efficiency compared to conventional polymers. Fundamental insights into structure–property relationships of 6FDA-based polyimide membranes observed in this study offer guidance for next generation membranes for sour natural gas separation.     

Mechanistic Insights into C(sp2)−C(sp)N Reductive Elimination from Gold(III) Cyanide Complexes

A new family of phosphine-ligated dicyanoarylgold(III) complexes has been prepared and their reactivity towards reductive elimination has been studied in detail. Both, a highly positive entropy of activation and a primary ^12/13C KIE suggest a late concerted transition state while Hammett analysis and DFT calculations indicate that the process is asynchronous. As a result, a distinct mechanism involving an asynchronous concerted reductive elimination for the overall C(sp²)−C(sp)N bond forming reaction is characterized herein, for the first time, complementing previous studies reported for C(sp³)−C(sp³), C(sp²)−C(sp²), and C(sp³)−C(sp²) bond formation processes taking place on gold(III) species.